EWRF Brown Bear 008 FPV Traversing Machine 5.8G Tower Graphic Transmitter 25/200/600mW Adjustable TBS

Key configuration Brown Bear 008

After the module is powered on, the LED indicator will display the current channel number, group and power value of the module in turn. The red and blue lights are always on and enter the normal working mode. At this time, long press the key to adjust the image transmission parameters

Step 1: Long press the key and the red light flashes once to enter channel frequency point configuration

At this time, press the key briefly to switch channel frequency points (1-8). One flash of the blue light indicates channel frequency point 1, and several flashes of the blue light indicate corresponding channel frequency points:

Step 2: Long press the key and the red light flashes twice to enter the channel grouping configuration.

At this time, press the button briefly to switch the channel group (A, B, C, D, E). The blue light flashes once to indicate channel group A. Each increase in the number of flashes of the blue light is expressed as (B, C, D, E);

Step 3: Long press the button again, when the red light flashes three times, enter the power configuration.

Short press the button to switch the power. One flash of the blue light means 25mw, two flashes means 200mw, and three flashes means 600mw.

Step 4: After adjusting the parameters, press and hold the key for a long time. The red and blue lights are always on to enter the save mode, and then enter the normal working state

(finally, press and hold the key for a long time to save the configured parameters, otherwise the module cannot exit the configuration state and save the configured parameters)

​

Pitmode switching

Under normal working conditions, press the key twice quickly to switch the Pitmode mode on and off

When the red light is always on, the blue light means entering the Pitmode mode; when the red light and blue light are always on, it means turning off the Pitmode mode and entering the normal power transmission state. Note: In Pitmode mode, the working distance is only about 1-2 meters.

Remember to reserve space for wind flow to ensure heat dissipation during installation of graphic transmission;

Otherwise, the transmission power will be reduced or even the transmission will be shut down after the overheat protection is started;

It is recommended to screw on the antenna before powering on to prolong the service life of the module.